Program My Garage

Brands / Chamberlain / 9950D

Chamberlain 9950D: Learn button and programming

Learn button
Purple (may fade to brown)
Technology
Security+
Type
screw
myQ / Wi-Fi
No
Battery backup
No
Manual dated
2007

Where it is: On the back or side panel of the motor unit, close to where the antenna wire hangs down.

✓ Checked against the maker's instructions · Chamberlain 9950D owner's manual

Program a remote to the 9950D

  1. Find the LEARN button on the opener motor unit.
  2. Press and release LEARN; its LED stays lit for about 30 seconds.
  3. Within those 30 seconds, press and hold the remote button you want to use.
  4. Let go when the opener lights blink or you hear two clicks.
  5. Press the remote button again to test.

Program a keypad

  1. Press and release the LEARN button on the opener motor unit.
  2. Within 30 seconds, type a 4-digit PIN of your choice on the keypad.
  3. Press and hold ENTER until the opener lights blink or you hear two clicks.
  4. Enter the PIN and press ENTER to test.

Program your car (HomeLink)

  1. Program the HomeLink button with your remote first (see your vehicle's steps).
  2. Press and release the LEARN button on the opener motor unit.
  3. Within 30 seconds, press and hold the programmed HomeLink button for 2 seconds, then release.
  4. Repeat up to 3 times until the door moves.

The first part happens in your car. Find your car's own steps in our car guides.

Erase all remotes

  1. Press and hold the LEARN button on the opener motor unit.
  2. Keep holding for about 6 seconds until the LEARN LED goes out.
  3. All remotes and keypads are now erased; reprogram the ones you want to keep.

After programming: test the safety reverse. Put a piece of wood or a roll of paper towels flat under the door and close it. The door should touch it and go back up. If it doesn't, don't use the opener until it's fixed.

Remotes and keypads that work with the 9950D

Buying a replacement? Match the Learn button colour, not just the brand.

More Chamberlain guides