Brands / Chamberlain / PD752CS
Chamberlain PD752CS: Learn button and programming
- Learn button
- Not yet checked
- myQ / Wi-Fi
- No
- Battery backup
- No
- Manual dated
- 2005
Where it is: On the back or side panel of the motor unit, close to where the antenna wire hangs down.
✓ Checked against the maker's instructions · Chamberlain PD752CS owner's manual
Program a remote to the PD752CS
- Find the LEARN button on the opener motor unit.
- Press and release LEARN; its LED stays lit for about 30 seconds.
- Within those 30 seconds, press and hold the remote button you want to use.
- Let go when the opener lights blink or you hear two clicks.
- Press the remote button again to test.
Program a keypad
- Press and release the LEARN button on the opener motor unit.
- Within 30 seconds, type a 4-digit PIN of your choice on the keypad.
- Press and hold ENTER until the opener lights blink or you hear two clicks.
- Enter the PIN and press ENTER to test.
Program your car (HomeLink)
- Program the HomeLink button with your remote first (see your vehicle's steps).
- Press and release the LEARN button on the opener motor unit.
- Within 30 seconds, press and hold the programmed HomeLink button for 2 seconds, then release.
- Repeat up to 3 times until the door moves.
The first part happens in your car. Find your car's own steps in our car guides.
Erase all remotes
- Press and hold the LEARN button on the opener motor unit.
- Keep holding for about 6 seconds until the LEARN LED goes out.
- All remotes and keypads are now erased; reprogram the ones you want to keep.
After programming: test the safety reverse. Put a piece of wood or a roll of paper towels flat under the door and close it. The door should touch it and go back up. If it doesn't, don't use the opener until it's fixed.